Installing Redpeaks

Introduction

To install Redpeaks is a very simple operation that should not take more than 10 minutes

Each new release of Redpeaks is 100% backward compatible with any previous version

Before installing or upgrading Redpeaks, it is advised to read the Release note first.

Prerequisites

Before installing Redpeaks, check the Prerequisites

Install procedure

Following steps describes how to install Redpeaks:

Install JAVA

Install Redpeaks on Linux

Install licenses

Install drivers

Create users

Get started

Once Redpeaks is installed, visit http://localhost:8888 or https://localhost:8443 to open its UI

You can start by applying your license

Then start configuring your SAP systems connectors and monitoring configuration

Configure integrations

Redpeaks uses plugins to integrate with a third party application:

Send alarms and metrics.

Send configration items.

Send reports

Go to the Plugins section and create the appropriate plugin

You can also use plugins to generate email notifications

Application Memory Setup

Memory tuning

Memory usage